Lamp
Light source lamp has a service life.
The picture will become dark or color will be poor when the lamp is used for a long time.
If usage of lamp is continued in such cases, it could cause a malfunction. Replace lamp with new one.
As reference for replacement time, indicator will operate or message will be displayed when the power is turned on, as shown on page 30~31. In these cases the lamp should be replaced. Consult your dealer.
Caution | Also LAMP indicator will light when the lamp becomes too hot. Turn off the power and let the | |
projector cool for 45 minutes. Turn on. If LAMP indicator still lights up red, contact your | ||
| ||
| dealer. |
1. How to replace lamp | (Option lamp : Lamp unit DT00201) |
|
HIGH VOLTAGE
HIGH TEMPERATURE
HIGH PRESSURE
When replacing lamp, turn off and remove AC cord, wait 45 minutes to let lamp cool.
Caution ∙ For disposal of used lamp, treat according to the instruction of community authorities.
∙Since the lamp is made of glass, do not apply shock to it and do not scratch it.
∙Also, do not use old lamp. This could also cause explosion of the lamp.
| ∙ If it is probable that the lamp has exploded | Reflector | Front glass |
| (explosive sound is heard), disconnect the power | ||
|
| ||
|
|
| |
| plug from the power outlet and ask your dealer to |
|
|
| replace lamp. The lamp is covered by front glass |
| Lamp |
| and |
| |
|
|
| |
| reflector and the inside of the projector may be damaged by scattered broken pieces of glass, | ||
| and broken pieces could cause injury when being handled. |
| |
1 | Turn the main power switch off and disconnect the power | ||
| plug from the power outlet. |
|
|
2 | Remove the lamp cover. |
|
|
∙ If lamp is hot at this time, this could cause burn. Wait |
|
| |
for minimum 45 minutes until lamp is cooled down. | Lamp cover | Screw |
∙ Loosen a screw and remove the cover. |
| |
|
|
3 Loosen two screws and pull the handle to remove the
lamp.
Screw
∙ If the screws are not loosened completely, your fingers
may be damaged.
Lamp
∙Do not insert your hand into the box after the lamp is removed.
(There are optical parts inside. If touched by hand, it may result in color unevenness, etc.)
30
