Hitachi CP-X2510N, CP-X3010N USB, CONTROL, LAN

BAT TERY

LAN

Connection to the ports (continued)

USB

USB B type jack

Pin Signal

1+5V

2 - Data

3+ Data

4Ground

CONTROL

D-sub 9pin plug

• About the details of RS-232C communication,

please refer to the following page.

Pin Signal Pin Signal Pin Signal

1(No connection) 4 (No connection) 7RTS

2 RD 5Ground 8CTS

3TD 6(No connection) 9 (No connection)

LAN

RJ-45 jack

87654

Pin Signal Pin Signal Pin Signal

1TX+ 4 - 7-

2 TX- 5-8-

3RX+ 6RX-

54321

678

Downloaded from www.Manualslib.com manuals search engine

Contents

Main Projector CP-X2010N/CP-X2510N/CP-X3010N User's Manual (detailed) Operating Guide Technical Example of computer signal Initial set signals Connection to the ports COMPONENT DY, ECb/Pb FCr/Pr Page USB CONTROL LAN To input SCART RGB signal; ex. To input component video signal to COMPUTER IN ports ex. RS-232C Communication 1. 2. 3. 4. Communicaion settings 1. Protocol 2. Command format 3. Response code / Error code Command Control via the Network 1. 2. 3. Communicaion Port When the authentication setting is enabled, the following settings are required. Command control settings [TCP #23] 1. Command format 2. Response code / Error code ("h" shows hexadecimal) [TCP #9715] 1. Command format 2. Response code / Error code Automatic Connection Break Authentication 1. 2. 3. 4. Network Bridge Communication Communication settings RS-232C Communication / Network command table RS-232C Communication / Network command table Page Page * ACTIVE IRIS is available only for CP-X2510N and CP-X3010N. Page Page RS-232C Communication / Network command table (continued) * Not all of the languages in the table are supported. Page * ACTIVE IRIS is available only for CP-X2510N and CP-X3010N. Page PJLink command