Note: For a device not supported by diagnostic codes in the ThinkPad Notebooks, see the manual for that device.
Numeric error codes
Table 2. Numeric error codes
Symptom or error | FRU or action, in sequence | |
|
| |
0177 | System board. | |
Bad SVP data, stop POST |
|
|
supervisor password in the EEPROM is not correct. |
|
|
|
|
|
0182 | 1. | Run the ThinkPad Setup program. Press F9, and |
Bad CRC2. Enter the ThinkPad Setup program and load |
| Enter to load the default setting. Then save the |
Setup defaults. - The checksum of the CRS2 setting in |
| current setting by pressing F10. |
the EEPROM is not correct. | 2. | System board. |
|
|
|
0183 |
|
|
Bad CRC of Security Settings in EFI Variable. Enter the |
|
|
ThinkPad Setup program. |
|
|
|
| |
0187 | System board. | |
EAIA data access error - The access to EEPROM is failed. |
|
|
|
| |
0188 | System board. | |
Invalid RFID Serialization Information Area. |
|
|
|
| |
0189 | System board. | |
Invalid RFID configuration information area - The EEPROM |
|
|
checksum is not correct. |
|
|
|
|
|
0190 | 1. | Charge the battery pack. |
Critical | 2. | Battery pack. |
|
|
|
0191 | 1. | Run the ThinkPad Setup program, and then save |
System Security - Invalid Remote Change requested. |
| current setting by pressing F10. |
| 2. | System board. |
|
|
|
0199 | 1. | Run the ThinkPad Setup program, and then save |
System Security - Security password retry count |
| the current setting by pressing F10. |
exceeded. | 2. | System board. |
|
|
|
0251 | 1. | Charge the backup battery for more than 8 hours |
System CMOS checksum bad - Default configuration |
| by connecting the ac power adapter. |
used. | 2. | Replace the backup battery and run the ThinkPad |
|
| setup program to reset the time and date. |
|
| |
0271 | Run the ThinkPad Setup program to reset the time | |
and date. | ||
|
|
|
2100 | 1. | Reseat the hard disk drive. |
Detection error on HDD | 2. | Main hard disk drive. |
| 3. | System board. |
|
|
|
2110 | 1. | Reseat the hard disk drive. |
Read error on HDD | 2. | Main hard disk drive. |
| 3. | System board. |
|
| |
2200 | System board. | |
Machine Type and Serial Number are invalid. |
|
|
|
| |
2201 | System board. | |
Machine UUID is invalid |
|
|
|
|
|
