Hitachi CR 13VA service manual Cr A B C D E F

7. COMPARISONS IN CUTTING TIME

The following test data should be used for reference purposes only since the cutting time may vary depending on

the operating conditions such as the cutting function, pressing force, type of blade, etc. The graph shows the time

(in sec.) required to cut a piece of each material.

7-1. Cutting Steel Pipes

A steel pipe less than 42 mm (1.65") in inner diameter and 3.2 mm (0.13") in thickness

HITACHI genuine blade No. 103 for cutting steel pipes

Pressing force about 4 kgf (8.8 lbs.)

CR 13VA

CR 10V

A

B

C

D

E

F

Straight cutting				Swing or orbital cutting
	Swing cutting
						Orbital cutting
			Orbital cutting
					Orbital cutting function is not provided.
		Orbital cutting function is not provided.
				Orbital cutting
					Orbital cutting function is not provided.

Orbital cutting

0	10	20	30	40	50
		Cutting time (sec./cut)

--- 10 ---