English

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting metal and stainless steel pipe.

Cutting various lumber.

Cutting mild steel, aluminum and copper plate.

Cutting synthetic resins, such as phenol resin and vinyl chloride.

REMOVAL AND INSTALLATION METHOD OF BATTERY

CAUTION: Be sure to keep the switch turned off and the lock-off button moved to right position (lock position). (See Fig. 21)

Handle

Insert

Pull out

Switch trigger

Latch

Battery

Push

Fig. 3

How to install the battery.

Align the battery with the groove in tool handle and slip it into place.

Always insert it all the way until it locks in place with a little click. If not, it may acci- dentally fall out of the tool, causing injury to you or someone around you. (Fig. 3)

How to remove the battery.

Withdraw battery from the tool handle while pressing the latches (2 pcs.) on the sides of the battery. (Fig. 3)

CHARGING METHOD

The following is an explanation of charging methods when using the battery charger UC18YRL.

NOTE: Before plugging into the receptacle, make sure the following points.

The power source voltage is stated on the nameplate.

The cord is not damaged.

WARNING: Do not charge at voltage higher than indicated on the nameplate.

If charged at voltage higher than indicated on the nameplate, the charger will burn out.

13