English

HOW TO USE THE CORDLESS RECIPROCATING SAW

CAUTION:

Avoid carrying it with your finger on the switch. A sudden startup can result in an unexpected injury.

Be careful not to let sawdust, earth, moisture, etc., enter the inside of the machine through the plunger section during operation. If sawdust and the like accumulate in the plunger section, always clean it before use.

Do not remove the front cover (refer to Fig. 5).

Be sure to hold the body from the top of the front cover.

During use, press the base against the material while cutting.

Vibration can damage the saw blade if the base is not pressed firmly against the workpiece. Furthermore, a tip of the saw blade can sometimes contact the inner wall of the pipe, damaging the saw blade.

Select a saw blade of the most appropriate length. Ideally, the length protruding from the base of the saw blade after subtracting the stroke should be larger than the material (see Fig. 17 and Fig. 19).

If you cut a large pipe, large block of wood, etc., that exceeds the cutting capacity of a blade; there is a risk that the blade may contact with the inner wall of the pipe, wood, etc., resulting in damage. (Fig. 18, Fig. 20)

To extend the lifetime, the lithium-ion battery equips with the protection function to stop the output. Therefore, if the tool is overloaded, the motor may stop. However, this is not the trouble but the result of protection function. In this case, release the switch of tool and eliminate the causes of overloading.

1.Switch operation

(1) Lock-off button

The tool is equipped with a lock-off button. To acivate the trigger lock, move the button to the right positon. Move the button to the left to operate the tool. (Fig. 21, Fig. 22)

CAUTION: Always lock the switch when carrying or storing the tool eliminate unintentional starting.

Stroke

Fig. 17

Fig. 18

Stroke

Fig. 19

Fig. 20

Lock-off button

Lock

Fig. 21

19