English
ASSEMBLY AND OPERATION
APPLICATIONS
○Use as a drill
Drilling of soft steel, plastic and aluminum materials
○Use as a screwdriver
Tightening and loosening of machine screws, wood screws and tapping screws
REMOVAL AND INSTALLATION METHOD OF BATTERY
○How to install the battery
Align the battery with the groove in tool handle and slip it into place.
Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. (Fig. 3)
○How to remove the battery
Withdraw battery from the tool handle while pressing the battery release buttons (2 pcs.) on the sides of the battery. (Fig. 3)
1.Insert the plug of battery charger into the receptacle.
WARNING
Do not use the electrical cord if damaged. Have it repaired immediately.
2.Insert the battery to the battery charger.
Insert the battery into the battery charger as shown in Fig. 4.
Battery
Insert
Pull out
Handle
Battery release button
Pilot lump
Battery Push
Fig. 4
Fig. 3
CHARGING METHOD
NOTE
Before plugging into the receptacle, make sure the following points.
○The power source voltage is stated on the nameplate.
○The cord is not damaged.
WARNING
Do | not charge | at | voltage higher |
than | indicated | on | the nameplate. |
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
3. Charging
○When the battery is connected to the battery charger, charging will commence and the pilot lamp will light on.
NOTE
If the pilot lamp does not light, pull out the plug from the receptacle and check if the battery is properly mounted.
○When the battery is fully charged, the pilot lamp will go out.
12