Hitachi DH30PB instruction manual Striking only DH30PC, Using the stopper Fig, Handle Bolt

English

CAUTION:

◯Exercise care in preparing a pilot hole suitable for the wood screw taking the hardness of the wood into consideration. Should the hole be excessively small or shallow, requiring much power to drive the screw into it, the thread of the wood screw may sometimes be damaged.

6.Striking only (DH30PC)

This rotary hammer can be set to striking only mode by pressing the push button and turning the change

lever to mark. (Fig. 10)

(1)Mount the bull point or cold chisel.

(2)Press the push button and set the

change lever to mark or mark. Then rotation is released, turn the grip

and adjust the cold chisel to desired position. (Fig. 11)

(3)Turn the change lever to mark. (Fig. 10)

Then bull point or cold chisel is locked.

7. Using the stopper (Fig. 12)

(1)Loosen the side handle, and insert the stopper into the handle bolt hole.

(2)Adjust the stopper position according to the depth of the hole and tighten the side handle securely.

8.How to use the drill bit (taper shank) and the taper shank

adaptor.

(1)Mount the taper shank adaptor to the rotary hammer. (Fig. 13)

(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 13)

(3)Turn the switch ON, and drill a hole in prescribed depth.

(4)To remove the drill bit (taper shank), insert the cotter into the slot of the taper shank adaptor and strike the head of the cotter with a manual hammer supporting on the rests. (Fig. 14)

Change Lever

Push Button

Fig. 10

Grip

Fig. 11

Handle Bolt

Knob on Side

Stopper Handle

Fig. 12

15