English

requiring much power to drive the screw into it, the thread of the wood screw may

sometimes be damaged.

Mounting hole

6. Using the stopper (Fig. 10)

(1)Loosen the knob on the side handle, and insert the stopper into the mounting hole on the side handle.

(2)Adjust the stopper position according to the depth of the hole and tighten the knob

securely.

7.How to use the drill bit (taper shank) and the taper shank adaptor.

(1)Mount the taper shank adaptor to the rotary hammer. (Fig. 11)

(2)Mount the drill bit (taper shank) to the taper shank adaptor. (Fig. 11)

(3)Turn the switch ON, and drill a hole in prescribed depth.

(4)To remove the drill bit (taper shank), insert the cotter into the slot of the taper shank adaptor and strike the head of the cotter with a manual hammer supporting on the rests.

(Fig. 12)

8. Using the side handle

Stopper

Side handle

Fig. 10

Front cap Grip

Drill bit

Taper shank adaptor

When you wish to change a position of the side handle, turn grip of the side handle counterclockwise to loosen it, and then fasten it firmly.

CAUTION:

When boring a hole, there can be a case where the machine attempts to rotate by the reaction at the time of penetrating a concrete wall and/or when a tip of the blade comes in contact with the rebar.

Firmly fasten the side handle and hold the machine with both of your hands. Unless you hold it securely, an accident can occur.

Fig. 11

Cotter Taper shank adaptor

Rests

Fig. 12

14

Page 14
Image 14
Hitachi DH 25PB Using the stopper Fig, Using the side handle, Mounting hole, Cotter Taper shank adaptor Rests