English
How to make the batteries perform longer.
Recharge the batteries before they become completely exhausted.
When you feel that the power of the tool becomes weaker, stop using the tool and recharge its battery. If you continue to use the tool and exhaust the electric current, the battery may be damaged and its life will become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after use. If such a battery is recharged immediately after use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery and recharge it after it has cooled for a while.
BEFORE USE
Check the work area to make sure that it is clear of debris and clutter.
Insert so that bit does not protrude from main unit
Fig. 6
2.Mounting and dismounting of the bit.
(1)Mounting the bit.
Insert a screwdriver bit etc. into the keyless drill chuck.
Firmly grasp the ring and tighten the sleeve by turning it toward the right (in the clockwise direction as viewed from the front) (See Fig. 7).
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.
OPERATION
1.Using the bit holder.
CAUTION:
● | Stow the bit in the specified location on the tool. |
| If the tool is used with the bit stowed improperly, |
| the bit may fall and cause bodily injury. |
● | Do not stow bits that are of a different length, |
| gauge or dimension than the plus driver bit |
Ring Sleeve
Tighten
Loosen
(65 mm long) included in the STANDARD |
ACCESSORIES. |
The bit may fall and cause bodily injury. |
(1)Removing the bit
Securely hold the main unit and pull out the bit by holding the tip with your thumb (Fig. 5).
Bit
Fig. 5
(2)Installing the Bit
Install the bit with steps opposite of when removing. Insert the bit so that the right and left sides are equal, as shown in Fig. 6.
Fig. 7
NOTE:
If the sleeve becomes loose during operation, tighten it further.
The tightening force becomes stronger when the sleeve is tightened.
(2)Dismounting the bit
Firmly grasp the ring and loosen the sleeve by turning it toward the left (in the counterclockwise direction as viewed from the front) (See Fig. 7).
CAUTION:
When mounting a bit into the keyless chuck, tighten firmly. If the sleeve is not tight, the bit may slip or fall out, causing injury.
NOTE:
Loosening stuck or hard to move sleeves.
Grasp the bit installed in the keyless chuck, in a vise or similar tool.
Set the clutch dial position to
Finally, rotate the sleeve to the left, and it will loosen.
14