English

OPERATION

1. Using the hook (Hook with bit holder or Light equipped hook)

WARNING: Whenusingthehook,paysufficientattentionsothatthemainequipment does not fall. If the tool falls, there is a risk of accident.

CAUTION:

●Do not attach the tip tool except phillips bit to the tool main unit when carrying the tool

main unit with the hook suspended from a waist belt.

Injury may result if you carry the equipment suspended from the waist belt with sharp

tipped components such as drill bit attached.5 4

The hook can be installed on the right or left side and the angle can be adjusted in 5 steps between 0° and 80°.

(1)Operating the hook

(a)Pull out the hook toward you in the direction of arrow (A) and turn in the direction of arrow (B) (Fig. 5).

(b)The angle can be adjusted in 5 steps (0°, 20°, 40°, 60°, 80°).

Adjust the angle of the hook to the desired position for use.

(2)Switching the hook position

CAUTION:

●If the tool falls, there is a risk that malfunction and/ or physical damage can occur. It is recommended that you also use fall-preventing wires, etc.

●Incomplete installation of the hook may result in bodily injury when used.

(a)Securely hold the main unit and remove the screw using a slotted head screwdriver or a coin (Fig. 6).

(b)Remove the hook and spring (Fig. 7).

(c)Install the hook and spring on the other side and securely fasten with screw (Fig. 6).

NOTE:

Pay attention to the spring orientation. Install the spring with larger diameter away from you (Fig. 8).

1.1Using the bit holder (Hook with bit holder) ￿ Installing the bit

Slide the bit from the side, and then insert firmly until the groove on the bit locks in the protruded section of the hook.

3

 

2

(A)

(B)

Hook

1

 

 

Fig. 5

Loosen

Screw

Fig. 6

Hook

Spring

Fig. 7

Screw

Larger diameter faces away Fig. 8

17