English
CAUTION:
The motor rotation may be locked to cease while the unit is used as drill. While operating the driver drill, take care not to lock the motor.
When setting the shift knob to “HIGH” (high speed) and the position of the clutch dial is “17” to “22”, it may happen that the clutch does not engaged and that the motor is locked. In such a case, please set the shift knob to “LOW” (low speed).
If the motor is locked, immediately turn the power off. If the motor is locked for a while, the motor or battery may be burnt.
Too long hammering may cause the screw broken due to excessive tightening.
A buzzing noise is produced when the motor is about to rotate; This is only a noise, not a machine failure.
THE SCOPE AND SUGGESTIONS FOR USES
Table 3
Work | Clutch dial position | Suggestions | ||
|
|
|
| |
| Wood |
|
| |
|
|
|
| |
Drilling | Steel |
| Use for drilling purpose. | |
|
|
|
| |
| Aluminum |
|
| |
|
|
|
| |
| Machine | 1 – 22 | Use the bit and socket matching the | |
Screw | screw | screw diameter. | ||
| ||||
tightening | Wood | 1 – | Use after drilling a pilot hole. | |
| screw | |||
|
|
| ||
22