Hitachi ED-X52 user manual Bright Ù Normal, Monitor OUT

SETUP menu

Item	Description
	Using the ▲/▼ buttons turns off/on the eco mode setting.
ECO MODE	BRIGHT Ù NORMAL
	• When the NORMAL is selected, acoustic noise and screen
	brightness are reduced.
	Using the ▲/▼ buttons switches the mode for mirror status.
MIRROR	NORMAL Ù H:INVERT Ù V:INVERT Ù H&V:INVERT
	If the Transition Detector is on and MIRROR status is changed,
	TRANSITION DETECTOR ON alarm (	53) will be displayed when
	projector is restarted after the AC power is turned off.
	Using ▲/▼ buttons switches the standby mode setting between
	NORMAL and SAVING.
	NORMAL Ù SAVING

•When SAVING is selected and the projector is in the standby state, the power consumption is lowered with some functional

STANDBY MODE restrictions as below.
	- The RS-232C communication control is disabled except turning
	the projector on and changing the STANDBY MODE setting.
	- The STANDBY of the MONITOR OUT (	below) is invalid, and no
	signal is output from the MONITOR OUT port.		38) is
	- The AUDIO OUT STANDBY of the AUDIO SOURCE (
	invalid, and no signal is output from the AUDIO OUT ports (			5).
	While the image signal from the input port chosen in step (1) is
	projected, the image signal from the input port selected in step (2)
	is output to MONITOR OUT port.
	(1) Choose a picture input port using
	▲/▼ buttons.
	Choose STANDBY to select the
	picture output in the standby mode.
	(2) Select one of the COMPUTER IN
	ports using ◄/► buttons.
MONITOR OUT	Select OFF to disable the MONITOR
	OUT port for the input port or
	standby mode chosen in the step (1).

•You cannot select COMPUTER IN1 in step (1) and COMPUTER IN2 in step (2) and vice versa.

•If you have changed the setting of STANDBY, it applies only to the current standby mode, NORMAL or SAVING, selected under STANDBY MODE, without changing the setting of the other mode. The factory settings are as follows:

- COMPUTER IN1 for the NORMAL mode of STANDBY MODE - OFF for the SAVING mode of STANDBY MODE

37