Care for main body
●Wipe off the toner/moisturizing product on the head and the body with a tissue. When dirt is difficult to remove, wipe it off with a cloth after saturating it with water and wring it thoroughly.
Do not clean the main body with water. Or do not dip in water, and do not pour water. (Cause of failure)
Make sure to turn OFF the switch. (Improperly turning on the switch may give a tingling sensation or result in malfunction or
CAUTION ★Do not use alcohol, benzine, or thinner. (Cause of deformation or discoloration)
How to preserve
Store the device on the included stand in a place free from excessive humidity or dirt. 
The stand can store the rings in it as well as put the body on it. (Fig. 12)
Do not leave in a water splashing area or an area with significant humidity, such as a bath. (Cause of
CAUTION ★Do not leave in an area subject to direct sunlight (inside of a vehicle in summer, etc.) or near heaters. (Cause of deformation or discoloration)
Specifications
Power | Power adaptor | 100 - 240V AC, common to |
supply | Main body | Batteries |
|
|
|
Charging time | 5 hours as standard | |
|
| |
Rated time | Around 15 minutes at the maximum | |
|
| (basic mode:approximate 10 minutes) |
|
| |
Accessories | Rings (two), stand | |
|
|
|
Disposal of the product
Do not disassemble except when disposing of the product.
This product includes recyclable parts.
For disposal of the parts, observe your local laws and regulations etc.
How to remove the nickel-hydrogen batteries
1.Keep pressing the power switch continuously while it is "ON" for about 10 seconds or more to make the device vibrate and leave it until the vibration stops.
2.Remove the two screws on the reverse side of the main body. (Fig. 13) 
Screws
3.Insert a
and (rear), and remove the main body case (rear). (Fig. 14)
Main body case (rear) |
4.Cut the lead wires connected to the terminals of the
Main body case (front) 
Lead wires 
Battery holder
Do not allow the (+) and
