3 Choose "the strength" of electrical potential with the level switch button.
Switch the "strength" with the Level switch button according to the condition of your
skin.
Every time the level indicator button is pressed, the high, medium, and low of the
electrical potential will be switched. There will be no change in vibration strength.
4 Hold the device with your hand touching the back plate of the body.
(Fig.5)
Make sure to hold the body with your hand touching the back plate.
5 Apply and move the heating head slowly.
(Fig.6)
When using a sheet mask, slide the head over the sheet mask.
The mode indicator lamp will switch and turn on, and the device will start to vibrate.
The time for use is within 3 minutes.
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the Level
switch button and switch to "LOW."
6 After 3 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
The finish sound (beep beep) will inform you.
Unless you apply the heating head to your skin while touching the back plate, the
device will not vibrate. (skin sensing function)
If the heating head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
CAUTION
7 After use, make sure to pull out the power adaptor from the electric outlet and the main
body.
(Fig.7)
To continue to use the next mode, do not disconnect the power adaptor.
8 Wipe off the lotion on the heating head and the body of the device with a tissue.
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "Low."
Do not keep the heating head in the same area of the skin, but move it
around. (Cause of problems with your skin or poor health)
Step 4 “COOL”
In this mode, the cooling head surface that is cooled about 10 below the ambient
temperature tightens the pores of your face.
Use this device at an ambient temperature from 10 to 40 . (If you
use “COOL” mode at low temperature, the head may be overcooled,
damaging the skin.)
CAUTION
Continuous use of the “COOL” mode makes it difficult to cool the cooling head.
The warning sound (beep beep) and the flashing “COOL” on the mode indicator lamp
will inform you.
Apply the heating head gently to the face and slowly move the device by sliding it
from the center of the face to the outer side.