The mode indicator lamp will switch and turn on, and the device will start to vibrate.
The time for use is within 3 minutes.
Add more toner or moisturizing product when the heating head does not
easily slide.
Apply the heating head gently to the face and slowly move the device by sliding it
from the center of the face to the outer side.
Unless you apply the cotton to your skin while touching the back plate, the device
will not vibrate. (skin sensing function)
If the heating head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
5 Apply the heating head directly to the skin and move it slowly.
(Fig. 6)
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the
Level switch button and switch to "LOW." If you still feel your skin tingling, use the
device by adding more toner or other cosmetics.
CAUTION
8 Wipe off the moisturizing product on the heating head and the body of the device with a
tissue.
6 After 3 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
The finish sound (beep beep) will inform you.
To continue to use the next mode, do not disconnect the power adaptor.
4 Hold the device with your hand touching the back plate of the body.
(Fig. 5)
Make sure to hold the body with your hand touching the back plate.
7 After use, make sure to pull out the power adaptor from the electric outlet and the
main body.
(Fig. 7)
Step 3
“HOT MASK”
(It is recommended that you use “HOT MASK” once a day for milky lotion or once or twice
a week for sheet mask.)
Fine vibrations and gentle switching of the electrode enhance the effect of milky lotion or
sheet mask.
1 Place a sheet mask on your face or spread milky lotion or cream that you would
normally use over your entire face.
Wipe off any
lotion
on your hands.
2 After confirming that the power adaptor is connected to the main body, press the
power switch. (Fig.10)
“Low” on the level indicator lamp lights and “
HOT MASK
” on the mode indicator lamp
starts flashing. If a lamp in another mode is flashing, press the mode switch button
to switch to “
HOT MASK
.”
When the "
HOT MOISTURIZE
" mode is finished, press the power switch and the
"
HOT MASK
" mode will automatically be set.
Do not keep the cotton on the same area of skin, it is necessary to
move it around.
(Cause of problems with your skin or physical discomfort.)