Hitachi KP-FD30 dimensions High resolution and high color fidelity, CCD drive functions

Preliminary

VGA Progressive Scan CCD Color Camera

KP-FD30/KP-FD30CL

1 / 2-inch RGB primary color filter progressive scan CCD image sensor RGB color camera High frame rate 60 frame per second

The KP-FD30 is equipped with the progressive full frame RGB output of high frame rate( approx. 60 frame per second ). Optionally The KP-FD30CL outputs Camera-Link. Both camera is equipped the external synchronization(HD/VD), the external trigger function, etc., it is suitable for the image-processing equipment input.

Major feature

Suitable for the image-processing equipment input.

Small lightweight size, since adoption of multi-connector with one cable.

High resolution and high color fidelity

By adoption of the progressive scan CCD image sensor and RGB primary color mosaic filters, the picture of high vertical resolution and high color fidelity can be acquired.

A new digital signal processor (DSP)

The clear picture of a high signal to noise ratio (S/N) is obtained by the new digital signal processor (DSP) adoption which has improved luminance signal processing, such as 5H enhancer processing.

CCD drive functions

.Preset electronic shutter ( settable 11 steps from 1/60 second to 1/50,000 second and

27 steps from 1/30 second to 8 second. )

.Variable electric shutter ( 1H steps from 1/60 second to Approx. 1/10,000 second )

.Auto electronic shutter[AES] ( from 1/60 second to approx. 1/50,000 second )

.Frame/field on demand ( one trigger and fixed shutter modes )

Output of NTSC system (2:1 interlace scan) (KP-FD30 only)

It can be set as the image output of NTSC system (2:1 interlace scan) by switch change

	Standard	Optionally	For OEM
Model	KP-FD30	KP-FD30CL	KP-FD30F	KP-FD30USB
Output format	Analog RGB	Camera Link	IEEEE-1394	USB2.0
Frame rate	60 frame per sec.	60 frame per sec.	30 frame per sec.	30 frame per sec.

Main specifications

Imaging device	1/2-inch progressive scan interline CCD
No. of effective pixels	659(H) × 494(V)
Unit cell size	9.9(H) x 9.9(V) m ( Square pixel )
Scanning area	7.48(H) × 6.15(V) mm
Color filter	R, G, B primary color mosaic filters on chip
Scanning system	Progressive scan ( VGA mode )
(Selectable by switch)	2:1 interlace scan ( NTSC mode )
Frequency	Horizontal: 31.468 kHz	Vertical: 59.94 Hz
Sync system	Internal / external ( HD/VD auto selection )
Internal sync output	:HD/VD/SYNC 2 Vp-p/75	, Negative polarity
	WE: 5 Vp-p, Negative
External sync input	HD/VD 2 to 5 Vp-p, Negative polarity
	EXT. Trigger input: Low 0 VDC, High 2 to 5 VDC
Video signal output	RGB output (G on SYNC)
	Y/C output ( Only at the NTSC mode )
	VBS output ( Only at the NTSC mode)
S/N ( Y signal )	More than 50dB ( AGC, enhancer and gamma off )
Resolution	Horizontal: 440 TV lines
( Y signal at center )	Vertical: 480 TV lines ( VGA mode ) 350 TV lines ( NTSC mode )
Standard sensitivity	2,000 lx ( F5.6, 100IRE )
Minimum illumination	10 lx ( F1.4, AGC ON, 50IRE )
Sensitivity selection	Gain Adjustable at AGC OFF and AGC Limit Gain
Electric shutter speed	Selectable in 11 steps high spped shutter
PRESET	OFF(1/60), 1/100, 1/250, 1/500, 1/1000, 1/2000, 1/4000
	1/10000, 1/20000, 1/30000, 1/50000 second
	: Approx. 1H steps from 1/60 second to 1/10,000 second
	Selectable in 27 steps low speed shutter
	OFF(1/60), 1/30, 1/15, 1/10, 1/7.5, 1/6, 1/5, 1/3.75, 1/3, 1/2.5, 1/2,
	1/1.5, 1, 1.5, 2, 2.5, 3, 3.5, 4, 4.5, 5, 5.5, 6, 6.5, 7, 7.5, 8 second
AES	From 1/60 second to approx. 1/50,000 second
	( Response : SLOW, NORMAL, FAST )
VARIABLE	Approx. 1H steps from 1/60 second to 1/10,000 second

Auto level ontrol [ALC]		( The auto level control system of AES, lens iris and AGC. )
		AVERAGE / PEAK&AVERAGE / AREA
		( Scanning area is selectable from 9 area. )
Auto-iris	lens	DC ( Iris control voltage input type lens, cable length over 150mm )
outputs [DC/VIDEO*]		: Coupling coil impedance Damper : 1,150 ±10% , Drive : 190 ±10%
		Power supply : 12 VDC, 60 mA
		Note :. "VIDEO" is optionally.
White balance		Selectable in 3 modes
		Auto-tracking[ATW]:2,500K~6,000K
		preset [AWC] : (2,500K~10,000K)
		R/B gain manual control [MANUAL] (2,500K~10,000K)
Text display		24 alpha-numeric characters in one line (only KP-FD30)
Picture adjustment		Modes and settings can be selected and adjusted from
		on-screen menu (only KP-FD30)
Remote control		Modes and settings can be selected and adjusted from PC
		by RS-232C level,
Power supply		12 VDC ± 10 %
		Approx.360 mA(KP-FD30) pprox.370mA(KP-FD30CL)
		(Including 60mA for auto-iris lens )
Lens mount		C/CS mount ( Frange-back adjustment )
Ambient temperature		Operating : -10 to +50 C, (+14 to +122 F) 30 to 80 %RH
		Storage : -20 to +60 C(-4 to +144 F), 20 to 90 %RH
Vibration endurance		68.6 m/s2 ( 10 to 200Hz, 30 minutes each on XYZ axes )
Shock endurance		490 m/s2 ( vertical, horizontal, once each face )
External dimensions		58(W) x 58(H) x 48(D) ( not including lens and protrusions )
Mass		Approx.220g ( without lens )

Note : If operated continuously, be sure to use at less than +40C(104F) for long term stable performance.

Please inquire detailed specifications of KP-FD30CL.