Remote control

 

 

 

(continued)

 

 

Inserting Batteries

1 Open the battery compartment cover in the direction of the arrow.

Install two “AA” batteries, paying

3

Replace the compartment cover.

2 attention to the polarity diagram in the

 

battery compartment.

 

 

Operation

 

Aim the remote control at the remote sensor and press control

Approximately 15 feet

buttons to operate.

Operate the remote control within a 30° angle on either side of

 

 

the remote sensor, up to a distance of approximately 15 feet.

 

NOTE:

 

Do not leave the remote control unit exposed to direct sunlight or in hot or humid places.

The remote control unit uses infrared beams to transmit signals, so sunlight or fluorescent light on the remote sensor may shorten

operating distance.

 

Incorrect use of batteries may cause them to leak or burst. Read the battery warnings and use the batteries properly.

Do not mix old and new batteries.

 

Do not mix alkaline, standard (carbon-zinc), or rechargeable, (ni-cad, ni-mh, etc) batteries.

Remove batteries if the remote control will not be operated for an extended period of time.

Please use caution when inserting batteries to avoid battery damage. If the spring terminal in the remote control remains in contact

 

with a side of a damaged battery it can cause a short circuit. Never use damaged batteries as they can become very hot and are

 

dangerous.

 

Power source

TO USE AC POWER

1. Connect the AC cord plug into this unit’s AC IN jack.

2. Connect the AC cord into an AC outlet.

AC Outlet

Wider Hole

and Blade

AC cord (supplied)

AC 120V, 60Hz

NOTE:

• Please make sure to insert the cord securely at both the LCD TV/DVD and the wall outlet.

• The AC Cord has a polarized type AC line plug. If the supplied AC cord does not match your AC outlet, contact a qualified electrician.

WARNING:

• DO NOT CONNECT THIS UNIT TO THE POWER USING ANY DEVICE OTHER THAN THE SUPPLIED AC CORD. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

• DO NOT USE WITH A VOLTAGE OTHER THAN THE POWER VOLTAGE SPECIFIED. THIS COULD CAUSE FIRE, ELECTRICAL SHOCK, OR DAMAGE.

CAUTION:

• WHEN THIS UNIT IS NOT USED FOR A LONG TIME, (E.G., AWAY ON A TRIP) IN THE INTEREST OF SAFETY, BE SURE TO UNPLUG IT FROM THE AC OUTLET.

• DO NOT PLUG/UNPLUG THE AC CORD WHEN YOUR HANDS ARE WET. THIS MAY CAUSE ELECTRICAL SHOCK.

• IF YOU NEED TO REPLACE THE SUPPLIED AC ADAPTER OR AC CORD, THE SPECIFIED ONE IS RECOMMENDED. CONTACT THE DEALER THAT YOU PURCHASED THE UNIT FROM.

12

54H0321A_eng.indd 12

5/4/10 3:44:29 PM

Page 12
Image 12
Hitachi L26D204 manual Power source, Inserting Batteries, Operation, To USE AC Power