Hitachi L42V651, L47V651 important safety instructions Precoded VCR/PVR Buttons, MY VCR/PVR Code is

TheHowRemoteto Use thefor RemoteVCR/PVRtoFunctionsControl Your TV

The Remote Control

OPERATING THE PRECODED FUNCTION FOR YOUR VCR/PVR (Personal Video Recorder).

This remote is designed to operate different types of VCRs/PVRs. You must first program the remote to match the remote system of your VCR/PVR (refer to pages 36-37 for pre-codes).

1.Turn ON your VCR/PVR.

2.To switch to VCR/PVR pre-coded mode, use the SOURCE SELECT button on the remote control to position the LED light to the corresponding selection PVR/VCR.

3.Hold down the SOURCE SELECT button on the remote and enter the four digit preset code that matches your VCR/PVR, as shown on pages 36-37. Release the SOURCE SELECT button. The indicator light will flash 3 times if the code was accepted.

4.Aim the remote at the VCR/PVR and press the POWER button. The remote will turn off your PVR when the correct four digit preset code is entered. When this occurs, the remote control is programmed for your VCR/PVR. If the VCR/PVR does not turn off, try a different four digit preset code.

5.The remote will now control your VCR/PVR.

NOTE: 1. If your VCR/PVR cannot be operated after performing the above procedures, your VCR/PVR code has not been precoded into the remote.

2.In the unlikely event that your VCR/PVR cannot be operated after performing the above procedures, please consult your VCR/PVR operating guide.

3.The remote control will remember the codes you have programmed until the

batteries are removed from the

remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿

	￿
￿
￿	￿
￿	￿

￿

￿

￿￿

￿￿

￿

￿PRECODED VCR/PVR Buttons

These buttons transmit the chosen precoded VCR/PVR codes :

-Power	-Cursor & Select	-Enter
-Menu	-Channel Up & Down	-Dash (-)
-Exit	-Number PAD	-Play,Pause,Stop
-Info	-Last CH	-FWD,Skip FWD
-Record	-RWD

￿EXCLUSIVE TV Buttons

These buttons are for operating the TV :

-Day/Night	-CC	-Inputs (only if
-Aspect	-Vol Up & Down	programmed,
		refer to page 35)
-PIP	-Mute

MY VCR/PVR CODE IS:

NOTE: Refer to instruction manual of the VCR/PVR for operation of the buttons exclusively for the VCR/PVR.

34