English

●After nailing:

1)disconnect air hose from the Nailer;

2)remove all nails from the Nailer;

3)supply 5 – 10 drops of Hitachi pneumatic tool lubricant into the air plug on the Nailer; and

4)open the petcock on the air compressor tank to drain any moisture.

ADJUSTING THE NAILING DEPTH

WARNING

●When adjusting the Adjuster, be sure to remove your finger from the trigger and disconnect the air hose from the nailer.

To assure that each nail penetrates to the same depth, be sure that:

1)the air pressure to the Nailer remains constant (regulator is installed and working properly), and

2)the Nailer is always held firmly against the workpiece.

If nails are driven too deep or shallow into the workpiece, adjust the nailing in the following order.

1DISCONNECT AIR HOSE FROM NAILER.

2If nails are driven too deep, turn the adjuster to the shallow side.

If nails are driven too shallow, turn the adjuster

to the deep side.

3Stop turning the adjuster when a suitable position is reached for a nailing test.

4Connect the air hose.

ALWAYS WEAR SAFETY GLASSES. Perform a nailing test.

5DISCONNECT AIR HOSE FROM NAILER.

6 Choose a suitable position for the adjuster.

Adjuster

15Disconnect air hose

Turn adjuster

2

Too deep

Flush

NOTE:

●The nail might not drive deep enough if using high pressure with the adjuster set upwards (shallow side) due to factors such as the material hardness or nail type.

If that happens, reduce pressure and set the adjuster to lowest position so the nail drives in at a good position.

2Turn adjuster

Too shallow

Flush

21