English
4Close the actuator.
2. Push down
1. Swing back
(4)Remove the finger from the trigger and press the push lever against the workpiece with pulling back the nail feeder (B). (NT50GS: Unnecessary to pulling back nail feeder)
THE NAILER MUST NOT OPERATE.
Do not pull trigger
Depress push lever
Nail feeder (B)
(5)Separate the push lever from the workpiece.
Next, point the nailer downward, pull the trigger and then wait in that position for 5 seconds or longer.
THE NAILER MUST NOT OPERATE.
Pull trigger
(6)Without touching the trigger, depress the push lever against the workpiece.
Pull the trigger.
THE NAILER MUST OPERATE.
(7)If no abnormal operation is observed, you may load nails in the Nailer.
Drive nails into the workpiece that is the same type to be used in the actual application.
THE NAILER MUST OPERATE PROPERLY.
LOADING NAILS
WARNING
When loading nails into Nailer,
1)do not pull trigger;
2)do not depress push lever; and
3)keep Nailer pointed downward.
<NT65GS, NT65GA, NT65GB>
(1)Insert nail strip into the back of the magazine.
Magazine
(2)Slide the nail strip forward in the magazine.
24