Hitachi NT 50GS, NT 65GA, NT 65GB, NT 65GS 27

Do not use the electrical cord if damaged.

Have it repaired immediately.

Never place your face, hands or feet closer than 8 inches (200 mm) from firing head when using.

Do not drive nails on the top of other nails or with Nailer at too steep of an angle; nails can ricochet and hurt someone.

Do not drive nails into thin boards or near corners and edges of workpiece. Nails can be driven through or away from workpiece and hit someone.

Never drive nails from both sides of a wall at the same time. Nails can be driven into and through the wall and hit a person on the opposite side.

Never use Nailer which is defective or operating abnormally.

Do not use Nailer as hammer.

Disconnect battery and fuel cell from Nailer when:

1)it is not in use;

2)leaving work area;

3)moving it to another location; and

4)handing it to another person.

Be careful of unwanted fastener.

If pulling the trigger more when not driving nail at the temperature below 30°F (0°C), an wanted fastener will be driven.

This Nailer is equipped with a FULL SEQUENTIAL ACTUATION MECHANISM. Explanation of FULL SEQUENTIAL ACTUATION MECHANISM nailing operation;

First, press the push lever against the workpiece;

next, pull the trigger to drive a nail.

NT65GS, NT65GA, NT65GB employ a preventive mechanism for unloaded operation.

NT65GS, NT65GA, NT65GB enter a state where the push lever cannot be pushed up. This takes place when the magazine is not loaded with nails or when the remaining number of nails becomes less than 6 or 9.

English

CAUTION

Use caution not to throw the push lever tip onto wood when the push lever cannot be pushed up.

METHODS OF OPERATION

CAUTION

Squeeze the push lever when drive a nail, otherwise the piston can not return correctly.

Make sure the nailing depth when the temperature is above 104°F (40°C) or below 32°F (0°C).

Using the tool for an extended period may lead to oil around the exhaust outlet or nose, resulting in spattering. To ensure that the material to be nailed stays clean, wipe off any oil that gets on the tool.

This Nailer is equipped with the push lever and does not operate unless the push lever is depressed (upward position).

It is intermittent operation (Trigger fire) only.

1Position the nail outlet on the

workpiece with finger off the trigger.

2Depress the push lever firmly until

it is completely depressed.

3Pull and squeeze the trigger to drive a nail.

4Remove finger from the trigger. To continue nailing in a separate location, move the nailer along the wood, repeating steps 1 - 4 as required.

3 2