Hitachi P42H4011A, P50H4011A Remote Control for DVD Functions, DVD Brand Codes

The Remote Control for DVD Functions

The Remote Control

OPERATING THE PRECODED

FUNCTION FOR YOUR DVD PLAYER.

This remote is designed to operate different types of DVD players. You must first program the remote to match the remote system of your DVD player (refer below for pre-codes).

1.Turn ON your DVD player.

2. To switch to DVD pre-coded mode, press and release the DVD button.

3. Hold down the DVD button on the remote and enter the two digit preset code that matches your DVD player, as shown below. Release the DVD button.

4. Aim the remote at the DVD player and press the POWER button. The remote will turn off your DVD player when the correct two digit preset code is entered. When this occurs, the remote control is programmed for your DVD player. If the DVD player does not turn off, try a different two digit preset code.

￿

￿

￿

￿

￿

￿

5. The remote will now control your DVD player.

NOTE: 1. If your DVD player cannot be operated after performing the above procedures, your DVD player’s code has not been precoded into the remote.

2.In the unlikely event that your DVD player cannot be operated after performing the above procedures, please consult your DVD player operating guide.

3.The remote control will remember the codes you have programmed until the batteries are removed from the remote control. After replacing the batteries repeat the entire programming procedure as stated above.

￿DVD button

This button allows the remote to control your DVD player by setting it to DVD mode.

￿PRECODED DVD Buttons

These buttons transmit the chosen precoded DVD codes.

￿EXCLUSIVE TV Buttons

These buttons are for operating the TV.

￿

DVD BRAND	CODES
APEX	10
GO VIDEO	09
HITACHI	00
KENWOOD	11
PANASONIC	02
PIONEER	03
RCA	04
SAMSUNG	06
SANYO	07
SONY	01
TOSHIBA	05
MY DVD PLAYER CODE IS: ______________________

NOTE: Refer to instruction manual of the DVD player for operation of the buttons exclusively for the DVD player.

30