Hitachi SP18VA instruction manual For use as a Polisher Using the backing pad Fig

English

ASSEMBLING AND DISASSEMBLING THE WOOL BONNET AND SANDING DISC

WARNING: Be sure to switch power OFF and disconnect the plug from the receptacle to avoid serious trouble.

●For use as a Polisher

<Using the backing pad (Fig. 4)>

(1)Press the lock pin to secure the spindle and tighten the backing pad by rotating the outer circumference.

(2)Adhere the wool bonnet (Hook & Loop type) attached by pressing it firmly against the backing pad. Align the respective centers when attaching. If not centered, vibration will result.

(3)To remove the wool bonnet, follow the above-mentioned procedure in reverse order.

Backing Pad

Fig. 4

Wool

Bonnet (Hook & Loop type)

Spindle

Lock Pin

<Using the rubber pad (optional accessory) (Fig. 5)>

(1)Insert the washer nut (optional accessory) through the rubber pad (optional accessory) and thread it onto the spindle.

(2)Press the lock pin to secure the spindle and tighten the washer nut with a wrench.

(3)Wrap the rubber pad with the hood of the wool bonnet (optional accessory) and firmly secure it by tying a string around it. Be sure the excess string is firmly tucked inside the wool bonnet to prevent it from flying out while polishing.

The unbalanced fitting of the wool bonnet may cause vibration (Fig. 6).

(4)To remove the wool bonnet, follow the above-mentioned procedure in reverse order.

Washer

Nut

Rubber

Pad

Fig. 5

Wool

Bonnet

Spindle

Lock Pin

Tuck the excess	Hood
string into
	Fig. 6

13