CONTROLLING THE TV

Once programmed, the VCR's remote control is ready to control the TV.

NOTE:

Be aware that not all of your TV's functions may work even though the remote control is correctly programmed.

1. Select the TV function mode

First press the TV button to change to the TV function mode, then press the button of the TV function that you want.

For example;

Press the TV button and the CH ( ), and the TV station will change to the next higher station.

NOTE:

Also, you may change the channels at the TV by using the number buttons. If you can not change the channels at the TV by using the number buttons, press the ENTER button after you press the number buttons. It may change channels at the TV.

2 Return to the VCR function mode

Press the VCR button to operate your VCR with the remote again.

TROUBLESHOOTING GUIDE

If you have followed the instructions contained in this manual and have difficulty in operating your VCR, locate the PROBLEM in the left column below. Check the corresponding CORRECTIVE ACTION columns to remedy the problem.

PROBLEM

CORRECTIVE ACTION

 

 

No power.

• Make sure the AC cord is connected to an AC outlet.

 

• Make sure the power is turned on.

 

 

Timer recording is not possible.

• Make sure the timer recording is set correctly.

 

• Make sure the power is off.

 

• Make sure the VCR clock is set correctly.

 

 

Cannot go into Record mode.

• Make sure the tape has an erase-prevention tab. If needed, cover

 

the hole with plastic tape.

 

 

Playback picture is partially noisy

• Adjust tracking control for a better picture by using the CHANNEL

 

or

button on the VCR.

 

 

No picture but the audio is OK in

• Head cleaning may be necessary. Refer to "HEAD CLEANING" on

playback.

 

page 35.

 

 

No picture or poor picture on

• Set your TV to the VCR mode and/or press the VCR/TV button on

playback.

the remote control so that the "VCR" indicator on the display comes

 

 

on.

 

• Fine tune your TV.

 

 

On-the-air TV programs cannot be

• Re-check the ANT. IN and ANT.OUT connections. See page 10.

seen.

• Set your TV to the TV mode and/or press the VCR/TV button on the

 

remote control so that the "VCR" indicator on the display disappears..

 

 

No operation from the infrared

• Make sure the AC cord is connected to an AC outlet.

Remote Control

• Check batteries in remote control

 

• If the TV or CATV button is selected, press the VCR button on the

 

 

remote control

 

 

Video or color fades in and out

• You cannot copy a copyrighted video tape. You are experiencing

when making a copy of a video tape

copy guard protection.