![](/images/new-backgrounds/1210075/21007521x1.webp)
English
6.Confirm the direction of bit rotation (Fig. 2)
The bit rotates clockwise (viewed from the rear side) when the reversing switch lever is set to the “R” side posi- tion. When the lever is set to the “L” side position, the bit rotates counter- clockwise and can be used to loosen and retract screws.
CAUTION:
Never change the bit rotating direction while operating the Screw Driver. Turn the main switch off before changing the rotating direction, otherwise, burn- ing of the motor will result.
7.Adjusting the tightening depth (Fig. 3)
Pull the lock sleeve in the direction of arrow to remove it from the spline in- stalled in the gear cover.
While pulling the lock sleeve and turn- ing it right and left, adjust the position of locator. Push the lock sleeve and aligen the gear cover spline with the lock sleeve spline.
The lock sleeve is inserted onto the gear
cover spline and locked.
(1)For
Mount a
(2)For drywall screws (Fig. 5)
Mount a drywall screw on the bit, and set the distance between the
(3)For
Mount a
R side
Lever
Fig. 2
SubLock
Stopper Locator sleeve Gear cover
Fig. 3
1 – 1.5 mm
Hex. head
Fig. 4
2 – 2.5 mm
Drywall
Fig. 5
11