English
4.Tightening Self-drilling screw
When the supplied magnet bit holder is used to tighten the Self-drilling screw into a steel plate, cut material stuck in the magnet bit will degrade the work efficiency.
To prevent this, the non-magnetic bit holder (optional accessory) is recom- mended. The stainless locator with bushing (optional accessory) will prevent the bushing from being worn.
MOUNTING AND DISMOUNTING THE HEX-SOCKET OR THE BIT
CAUTION
Be sure to switch power OFF and disconnect the plug from receptacle to avoid serious trouble.
1.Dismounting the hex-socket (Fig. 7)
(1) While rotating the Sub-Stopper pull it out from the locator.
(2) Remove the hex-socket, hold it with the opposite side of bit with hand or vise and pull out the bit with pliers.
2.Dismounting the bit (Fig. 8)
Remove the sub-stopper (A) alike case of hex-head socket and remove the bit holder, then pull out the bit with pliers.
Sub-Stopper (B)
Magnetic hex. socket
Fig. 7
3.Dismounting the bit (Fig. 9)
Remove the sub-stopper (C) alike case of hex-head socket and remove the bit holder, then pull out the bit with pliers.
4.Mounting the hex-socket or the bit
Install the bit in the reverse order to removel.
Sub-Stopper (A)
Bit Bit holder (Short type)
Fig. 8
Sub-Stopper (C)
Bit Bit holder
Fig. 9
