English
ASSEMBLY AND OPERATION
APPLICATIONS
Rotation and striking function
◯Drilling anchor holes
◯Drilling holes in concrete
◯Drilling holes in tile Rotation only function
◯Drilling in steel or wood
◯Tightening machine screws, wood screws
REMOVAL AND INSTALLATION METHOD OF BATTERY
1.Turn the body upside down and hold it firmly. Then, open the plate assembly while pulling the slide lever. (Fig. 3) To remove the battery, pull it out while holding the body tightly. (Fig. 4)
2.Pay attention to the inserting direction of the battery, insert the battery, and close the plate assembly. When the plate assembly and the slide lever engage each other perfectly, there will be the sound of a click. (Fig. 5)
Open |
| Pull out |
| Close | |
| Plate ass’y |
|
| Insert | |
|
|
|
| ||
Pull |
|
|
|
| |
|
|
|
| Plate | |
|
|
|
| ass’y | |
| Rechargeable |
|
| Body | |
Slide lever | Body | Rechargeable | Slide lever | ||
battery | |||||
battery | |||||
|
|
|
| ||
Fig. 3 | Fig. 4 |
| Fig. 5 | ||
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
◯The power source voltage is stated on the nameplate.
◯The cord is not damaged.
WARNING: Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the charger will burn up.
1.Insert the plug of battery charger into the receptacle.
When the plug of battery charger has been inserted into the receptacle, pilot lamp will
12blink in red. (At
