Hitachi Koki USA DH 24PC HOW to USE the Core BIT for Light Load, Mounting, How to bore Fig

English

HOW TO USE THE CORE BIT (FOR LIGHT LOAD)

When boring penetrating large hole use the core bit (for light load). At that time use with the center pin and the core bit shank provided as optional accessories.

1. Mounting

CAUTION:

◯Be sure to turn power OFF and disconnect the plug from the receptacle.

(1)Mount the core bit to the core bit shank. (Fig. 17)

Lubricate the thread of the core bit shank to facilitate disassembly.

(2)Mount the core bit shank to the rotary hammer. (Fig. 18)

(3)Insert the center pin into the guide plate until it stops.

(4)Engage the guide plate with the core bit, and turn the guide plate to left or right so that it does not fall even if it faced downward. (Fig. 19)

Guide Plate

Center Pin Core Bit Tip

Core Bit

Thread

Core Bit Shank

Fig. 17

Core Bit

Fig. 18

	Fig. 19
2. How to bore (Fig. 20)
(1)	Connect the plug to the power source.
(2)	A spring is installed in the center pin.
	Push it lightly to the wall or the floor
	perpendicularly. Connect all over the
	surface of the core bit tip and start op-
	erating.
(3)	When boring about 3/16" (5 mm) in
	depth the position of the hole will es-	Fig. 20

tablish. Bore after that removing the center pin and the guide plate from core

16bit.