Hobart 1612P manual Installation, Unpacking, Assembly, Electrical Clean Before Using

INSTALLATION

UNPACKING

Immediately after unpacking the slicer, check it for possible shipping damage. If this machine is found to be damaged, save the packaging material and contact the carrier within 15 days of delivery.

Prior to installing the slicer, test the electrical service to assure it agrees with the specifications on the machine data plate.

ASSEMBLY

The container of oil marked Lubriplate FM0-200-AW is for machine lubrication. Refer to LUBRICATION, page 8.

Remove the carriage tray from its shipping location, place it in position on the carriage support (Fig.1), and secure it by tightening the thumb screw. The two washers must be on the bottom, next to the thumb screw, to fit properly.

Locate the knife sharpener, packed loose in the shipping carton, and store it in a location where you can find it when the knife needs sharpening. Refer to KNIFE SHARPENING, pages 6 – 7.

Carriage Tray

Thumb Screw

Meat Grip

Carriage Support

PL-40617-1

Fig. 1

ELECTRICAL

WARNING: THIS MACHINE IS PROVIDED WITH A THREE-PRONG GROUNDING PLUG. THE OUTLET TO WHICH THIS PLUG IS CONNECTED MUST BE PROPERLY GROUNDED. IF THE RECEPTACLE IS NOT THE PROPER GROUNDING TYPE, CONTACT AN ELECTRICIAN.

CLEAN BEFORE USING

This slicer must be thoroughly cleaned and sanitized after installation and before being used. Refer to CLEANING, pages 5 – 6.

– 3 –