MAINTENANCE
KNIFE SHARPENING
The Hobart cast stainless steel knife will provide long service in normal food retail or commercial kitchen use. However, in high volume applications where it is a practice to sharpen the knife frequently or even daily, the knife will be expended in a shorter time.
Sharpen only when necessary; prolonged or too frequent sharpening results in unnecessary knife wear.
WARNING: UNPLUG MACHINE POWER CORD.
Turn the index knob fully clockwise to close the gauge plate. Remove the Top Knife Cover by rotating the Latch Knob counterclockwise and lifting it off the slicer. Thoroughly wash the area around the knife, the exposed knife surfaces, and the knife edge. Fat from meat or cheese should not be allowed to transfer from the knife to the sharpener.
Plug in machine power cord. With the carriage tray pulled fully forward, start the slicer with your right hand by pulling the start switch forward and holding it out. With your left hand, lift the sharpener handle until horizontal. Pull the sharpener handle fully forward for 5 seconds (Fig. 11). Slowly release the sharpener handle. Release the switch knob to turn the slicer off.
If necessary, repeat sharpening for another 5 seconds.
Unplug machine power cord. Wipe the slicer with a clean damp cloth to remove any grinding particles. Replace the Top Knife Cover.
LUBRICATION — Carriage Slide Rod
TO SHARPEN:
PULL SHARPENER HANDLE FULLY FORWARD
FOR 5 SECONDS
TOP KNIFE COVER
IS REMOVED
Fig. 11
Lubricate the Carriage Slide Rod with Lubriplate
|
|
| WICK HOLE | |
|
|
|
| |
drops every 2 – 3 months (depending on usage) in |
|
|
|
|
the Wick Hole on the Carriage Transport (Fig.12). |
|
|
|
|
Or, once monthly, apply 4 – 5 drops directly on the |
|
|
|
|
Carriage Slide Rod on each side of the Carriage |
|
|
|
|
Transport (Fig.12). |
|
|
|
|
To apply oil, pull out the telescoping tube on the oil |
|
|
|
|
CARRIAGE SLIDE ROD |
|
| ||
bottle, aim the tube, and squeeze gently on the |
|
|
|
|
|
|
|
| |
|
|
| CARRIAGE TRANSPORT | |
sides of the bottle. After applying oil, move the |
|
|
|
|
Carriage Tray back and forth a few times so the oil |
|
|
|
|
spreads over the entire length of the slide rod. | Fig. 12 |
| |
OVERLOAD RESET BUTTON — MODEL 2912 |
|
Push the reset button underneath the slicer near the
SERVICE
Contact your local
FORM 34371 | – 8 – | PRINTED IN U.S.A. |