Hobart D300 manual Troubleshooting, Bowl Lift Slideways, Service

Bowl Lift

The bowl lift mechanism should be lubricated twice a year. Loosen the knob and remove the bowl lift access cover from the rear of the pedestal. Lightly coat moving parts (Fig. 6) with Lubriplate 630AA (supplied). Replace access cover and tighten knob.

Bowl Lift Slideways

The slideways (Fig. 7) should be lubricated once each month. Remove the apron (secured by two thumb screws) from the front of the pedestal. Lightly coat both slideways with Lubriplate 630AA (supplied). Replace the apron and thumbscrews.

Bowl Lift Mechanism

PL-40171-1

Fig. 6

Bowl Lift Slideways

PL-40170-1

Fig. 7

TROUBLESHOOTING

SYMPTOMS		POSSIBLE CAUSES
Mixer will not start.	1.	Gear shift lever between gears (not fully engaged).
	2. Circuit protector in open position — check fuse or
		disconnect switch.
	3.	Mixer or attachment overloaded.
	4.	Bowl not all the way up.
	5.	Wire Cage Assembly is not in the front-center position.

SERVICE

If service is needed on this equipment, contact your local Hobart Service Office.

FORM 18816 Rev. A (Feb. 2000) – 12 – PRINTED IN U.S.A.