MAINTENANCE

WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECT SWITCH INDICATING THAT YOU ARE WORKING ON THE CIRCUIT BEFORE PERFORMING ANY MAINTENANCE PROCEDURE.

LUBRICATION

A list of acceptable lubricants, as well as the lubricants themselves, are available from your local Hobart Service Office.

Line Strainers

Line strainers used in water or steam lines should be cleaned one week after machine installation and periodically thereafter.

Motors

All motors have sealed bearings and require no lubrication maintenance.

Conveyor Gearmotor

Check the oil level in the conveyor gearmotor at the unload end of the machine every six months by removing the gear case plug (Fig. 31). The oil level should be at the bottom of the plug hole. The gear case can be drained from the Drain Plug on the front side (Fig. 32). Use only Mobilgear # 630 to replenish or replace.

GEAR CASE

 

CONVEYOR MOTOR

 

 

 

REMOVE PLUG

TO CHECK OIL LEVEL

PL-41059-1

Fig. 31

Conveyor Drive Chain

Inspect the drive chain (Fig. 33) regularly and lubricate as required with Grafo Concentrate A (supplied).

Conveyor Sprocket Bearings

Located at the loading and unloading ends, these bearings should be lubricated every four months. Grease fittings (Fig. 33), one at each of the four bearings, a grease gun, and 4 ounces of Alvania #2 grease are provided for this purpose.

DRAIN PLUG

PL-41060-1

Fig. 32

DRIVE CHAIN

GREASE FITTING

PL-41058-1

Fig. 33

– 12 –

Page 12
Image 12
Hobart FT900 SERIES manual Lubrication