Operation and Care of
FT900 SERIES DISHWASHERS
SAVE THESE INSTRUCTIONS
OPERATION
MACHINE PREPARATION — Check before beginning operation.
Raise the machine doors and make sure all components are in their proper operating positions.
Pump Intake Screens must be put on holders at each pump intake (Fig. 1).
Strainer Pans must be in place on top of each tank (Fig. 2).
Strainer Baskets must be in place in Strainer Pans (Fig. 3).
Fig. 1 | Fig. 2 | Fig. 3 |
End Caps must be correctly installed at ends of all Wash Arms (Fig. 4).
Wash Arms must be properly installed and latched in place (Fig. 5).
The Flush Arm at load end must be properly installed (Fig. 6).
Fig. 4 | Fig. 5 | Fig. 6 |
The Final Rinse Arm must be properly
installed (Fig. 7).
Fig. 7
Final Rinse Actuators must move freely, if so equipped (Fig. 8).
Fig. 8
Curtains must be in their proper places (Fig. 30, pages
A Short Curtain on the unload side of each upper Prewash, Wash, and Power Rinse Arm,
Long Curtains on both sides of every section divider,
Two Long Curtains at the Load End.
© HOBART CORPORATION, 1998
– 2 –
