Hobart H600 manual Operation, ELECTRO-MECHANICAL TIMER CONTROLS when equipped

OPERATION

WARNING: MOVING BEATER IN BOWL, KEEP HANDS, CLOTHING, AND UTENSILS OUT WHILE IN OPERATION, DO NOT USE WITHOUT INTERLOCKED GUARD.

Every H600 and L800 mixer is equipped with either an Electro-Mechanical Timer Control (described at the bottom of this page) or a Programmable Timer Controller (described on pages 7 – 9). Also, become familiar with the other operating parts (Fig. 2) and their functions, which are referenced throughout the OPERATION section (pages 6 – 12).

The Bowl Guard must be in position or the mixer will not operate. Refer to page 11.

If the Bowl Support is not all the way up, the mixer will not operate unless the START button is held in.

					Contols
								Gear Shift Lever
	Attachment Hub
							Handwheel
			Drip Cup
		Bowl Guard						Apron
Bowl Scraper
							Agitator
Attachment (optional)
		Bowl Handle
						Alignment Pin
								Bowl Clamp
				Bowl
								Bowl Support

PL-40067-1

Fig. 2

ELECTRO-MECHANICAL TIMER CONTROLS (when equipped)	8	9 10 11 12
			13
The START button is used to start the mixer.	7		14
	6		15
	5
The STOP button is used to stop the mixer.	4
	2		HOLD
	3
		1	0
The TIMER is used in conjunction with the START	START

button for timed mixing operations and will stop the mixer when a preset time has elapsed.

For non-timed mixing — Set the timer on HOLD

TIMER

START BUTTON

STOP BUTTON

and use the STOP button to stop the mixer.

STOP

PL-51306

Fig. 3

– 6 –