Hobart H600 manual PROGRAMMABLE TIMER CONTROLLER when equipped, For Continuous Mixing, Timer Keys

PROGRAMMABLE TIMER CONTROLLER (when equipped)

At Idle, the timer display [ – – : – – ] shows that no time has been set (Fig. 4).

										TIME
	P1			TIMER		CONTROL				DISPLAY
										KNOB
	KEY
			P1
	P2
				1		2	3	4
	KEY				TIME					SAVE
			P2						SAVE
										KEY
	M/C									CLEAR
	INDICATOR		M / C						CLEAR	KEY
										START
		START								BUTTON
										STOP
		STOP								BUTTON
											PL-51307
					Fig. 4
Timer Keys	Programming Function (if the mixer is not mixing).
P1	Contains up to four preset times. Displays each preset time sequentially.
P2	Contains up to four additional preset times. Displays each preset time sequentially.
Knob	Changes the time as indicated by the display.
Save	Replaces the preset time with the indicated time.
Clear	Returns to Idle from a programming function.

For Continuous Mixing . . .

START and STOP buttons control mixing operation.

Beginning from the Idle display [ – – : – – ], press START to begin mixing. The M/C indicator will be lit, and the total mixing time will be indicated (minutes and seconds).

Press STOP when mixing is done; the M/C indicator light goes off; and the Idle display [ – – : – – ] returns.

Using the Dial Timer to set the Mixing Time . . .

Beginning from the Idle display [ – – : – – ], turn the KNOB to set the mixing time. The M/C indicator will be lit.

START and STOP buttons control mixing operation.

Press START to begin mixing: The timer will countdown from the set time to [00 : 00].

If STOP is pressed, both mixing and timer countdown will be interrupted. After pressing STOP . . . Press START to resume both mixing and timer countdown; or, press CLEAR to return to the Idle display.

When the timer reaches [ 00 : 00 ] the mixer stops; M/C indicator goes off; a beep

tone sounds for two seconds; and the Idle display [ – – : – – ] returns.

– 7 –