Super IO Device:

Phoenix – AwardBIOS CMOS Setup Utility

Super IO Device

 

 

 

 

Onboard FDC Controller

[Enabled]

 

Item Help

Onboard Serial Port 1

[3F8 / IRQ4]

_________________________

Onboard Serial Port 2

[2F8 / IRQ3]

 

UART Mode Select

[Normal]

Menu Level ►►

RxD, TxD Active

[Hi, Lo]

 

IR Transmission Delay

[Enabled]

 

UR2 Duplex Mode

[Half]

 

Use IR Pins

IR-Rx2Tx2

 

Onboard Parallel Port

[378 / IRQ7]

 

Parallel Port Mode

[SPP]

 

EPP Mode Select

[EPP1.7]

 

ECP Mode Use DMA

[3]

 

 

Game Port Address

[201]

 

 

Midi Port Address

[330]

 

 

Midi Port IRQ

[10]

 

 

↑↓←→: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

Onboard FDC Controller:

Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you wish to use it. If you install and-in FDC or the system has no floppy drive, select “Disabled” in the field.

Enabled / Disabled

Onboard Serial Port 1 / 2:

Select an address and corresponding interrupt for the first and second serial ports.

3F8/IRQ4 / 2E8/IRQ3 / 3E8/IRQ4 / 2F8/IRQ3 / Disabled / Auto

UART Mode Select:

This field allows the users to configure what IR mode the 2nd serial port should use. Normal / IrDA and ASKIR

RxD, TxD Active:

This field configures the receive and transmit signals generated from the IR port. Hi, Hi / Hi, Lo / Lo, Hi / Lo, Lo

IR Transmission Delay:

This item allows you to “Enabled” or Disabled” the IR transmission delay.

Enabled / Disabled

UR2 Duplex Mode:

This item allows you to select IR “Half” or “Full” duplex function.

42

http://www.TYAN.com

Page 42
Image 42
Tyan Computer S2498 Super IO Device Phoenix AwardBIOS Cmos Setup Utility, Onboard FDC Controller, Onboard Serial Port 1