Swap Floppy Drive, Boot Up Floppy Seek | Tyan Computer S2498

Enabled / Disabled

Swap Floppy Drive:

This option allows the system to swap floppy drive.

Disabled / Enabled

Boot Up Floppy Seek:

This option allows the system to seek floppy drive when boots up.

Enabled / Disabled

Boot Up NumLock Status:

This option allows you to select power on state for NumLock.

Off / On

Gate A20 Option:

Select if chipset or keyboard controller should control GateA20. When set to Fast, the system chipset controls Gate A20. When set to Normal, a pin in the keyboard controller controls Gate A20. Setting Gate A20 to Fast improves system speed, particularly with OS/2 and Windows.

Normal / Fast

Typematic Rate Setting:

Toggles control of keyboard key repeat rate.

Enabled/Disable

Typematic Rate (Chars/Sec):

Defines how many characters are repeated per second when holding down a key on the keyboard.

6 / 8 / 10 / 12 / 15 / 20 / 24 / 30

Typematic Delay (Msec):

Defines the delay that occurs at keystroke before that key will start to repeat. 250 / 500 / 750/ 1000

Security Option:

Sets the password on either just the BIOS setup or the entire system (BIOS setup included). Setup / System

APIC Mode:

This option allows you to enabled or disabled Advanced Programmable Interrupt Controller (APIC) Mode.

Enabled / Disabled

MPS Version Control For OS:

Selects APIC mode depending on operating system: select 1.1 for Win NT 3.52, and 1.4 for Win NT4.0, Win2000 and WinXP

1.4 / 1.1

OS Select For DRAM > 64MB:

Select OS2 only if you are running OS/2 operating system with more than 64MB of RAM. Non-OS2 / OS2

Video BIOS Shadow:

This option allows you to enabled copies Video BIOS to shadow RAM Improves performance.

32

http://www.TYAN.com

Image 32

Tyan Computer S2498 Swap Floppy Drive, Boot Up Floppy Seek, Boot Up NumLock Status, Gate A20 Option, Typematic Delay Msec

Contents

Tomcat K7M Table of Contents Before you begin… Check the box contents Introduction Power RegulatoryForm Factor OS Operating System Support How to install our products right…. the first time Board InstallationInstallation Board Image S2498 Tomcat K7M Block Diagram Block Diagram Board Parts, Jumpers and Connectors JP13 JP8, JP14JP7, *JP15 J37 PIN Cmos Reset JP13 DefaultCmos S/PDIF Header J1 USB Header JP2 Audio Header J5 LAN1 LED Header JP8, JP14 10 *LAN2 LED Header *JP7, *JP15, *JP16 Internal Audio Connector Cdin VGA Header J37 Mounting the Motherboard Installing the Memory = 9 Chips Memory Installation Procedure Installing the Processor and Heatsink Finishing Installing the Heatsink Attaching Drive CablesPage Page Installing Add-In Cards Disconnect power supply from electrical outlet Connecting External DevicesInstalling the Power Supply Finishing Up Bios Setup Starting SetupSetup Basics Key Function Getting Help Case of ProblemsSetup Variations Main Bios Setup Load Optimized Defaults Supervisor / User PasswordSave & Exit Setup Exit Without Save Standard Cmos Features Phoenix AwardBIOS Cmos Setup Utility Standard Cmos FeaturesDate / Time Setup IDE Master / Slave Setup Video Halt On Advanced Bios Features Boot Up Floppy Seek Boot Up NumLock StatusTypematic Rate Setting Typematic Delay Msec Hard Disk Boot Priority First / Second / Third Boot DeviceBoot Other Device Small Logo EPA Show Advanced Chipsets Features System Bios CacheableMemory Hole： Video RAM Cacheable Current FSB Frequency Current Dram FrequencyDram Clock Dram Timing Dram Command Rate Write Recovery TimeAGP Mode Active to CMD Trcd CPU Direct Access FB TVConnectorAGP Fast Write AGP Master 1 WS Write Phoenix AwardBIOS Cmos Setup Utility CPU & PCI Bus Control PCI Delay TransactionPCI1/PCI2 Master 0 WS Write PCI1/PCI2 Post Write Phoenix AwardBIOS Cmos Setup Utility Integrated Peripherals VIA OnChip IDE Device Phoenix AwardBIOS Cmos Setup UtilityIntegrated Peripherals Init Display First Sata Mode IDE Prefetch ModeIDE HDD Block Mode VIA OnChip PCI Device Phoenix AwardBIOS Cmos Setup Utility AC97 Audio MC97 ModemOnchip USB Controller OnChip Ehci Controller Super IO Device Phoenix AwardBIOS Cmos Setup Utility Uart Mode SelectIR Transmission Delay UR2 Duplex Mode Use IR Pins Parallel Port ModeEPP Mode Select ECP Mode Use DMA Power Management Setup Modem Use IRQ Soft-Off by PwrbtnRun Vgabois if S3 Resume Ac Loss Auto Restart PowerOn by PCI Card RTC Alarm ResumeUSB Resume from S3 PCI Master IRQ3,4, 5, 6, 7, 12, 13 Primary IntrIRQ8, 9, 10, 11 PnP/PCI Configurations Phoenix AwardBIOS Cmos Setup Utility PC Health Status CPU Warning TemperatureShutdown Temperature PC Health Status Frequency/Voltage Control Auto Detect PCI ClkSpread Spectrum CPU Clock Load Fail-Safe Defaults Load Optimized DefaultsLoad Fail-Safe Defaults Y/N? N Load Optimized Defaults Y/N? N Supervisor/User Password Setting Enter Password Password Disabled Save to Cmos and Exit Y/N? Y Exit Without Saving Phoenix AwardBIOS Cmos Setup Utility Quit without saving Y/N? Y Flash Utility DiagnosticsMemory, Video, CPU Beep Codes Appendix I Glossary Page Mirroring see RAID Page Page Returning Merchandise for Service Technical Support Document # D1650-101