2-2. Installing And Aligning Wire Guide And Drive Roll
When changing wire size or type, check drive roll and wire guide size (see Parts List).
Installing Wire Guide And Drive
Rolls:
1 Drive Roll Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4 Inlet Wire Guide Screw
5 Inlet Wire Guide
Loosen securing screw. Install inlet guide so inlet guide screw is centered in groove in guide, or so tip is as close to drive rolls as possible without touching. Tighten screw.
Aligning Wire Guide And Drive
Rolls:
Only top drive roll alignment is ad- justable. Turn adjustment screw in or out until groove in drive roll lines up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean grooves using a wire brush.
5
4
3
Tools Needed:
1 2
3/16 in
3/8 in
