4-8. Wire Drive/Gun Troubleshooting Table
Wire Drive/Gun Trouble | Remedy |
|
|
Electrode wire feeding stops during | Straighten gun cable and/or replace damaged parts (see Section |
welding. |
|
|
|
| Adjust drive roll pressure (see Section |
|
|
| Readjust hub tension (see Section |
|
|
| Check circuit breakers CB1 and/or CB2, and reset if necessary (see Section |
|
|
| Replace contact tip if blocked (see Section |
|
|
| Clean or replace wire inlet guide or liner if dirty or plugged (see Section |
|
|
| Replace drive roll if worn or slipping (see Section |
|
|
| Secure gun plug in receptacle or repair leads, or replace trigger switch (see Section |
|
|
| Check and clear any restrictions at drive assembly and liner (see Section |
|
|
| Have nearest Factory Authorized Service Agent check drive motor. |
|
|