Hobart Welding Products 250A manual Connecting Work Clamp, Connecting Input Power

4-6. Connecting Work Clamp

1

1Work Clamp

2Workpiece

Connect work clamp to a clean, paint-free location on workpiece, as close to cutting area as possible.

2

802 463-A

4-7. Connecting Input Power

Check input voltage available at site.

	1	Grounded Receptacle
2	A 120 volt, 20 ampere individual
	branch circuit protected by
	time-delay fuses or circuit breaker
	is required (see Section 4-1).
1	2	Plug From Unit

Select extension cord of 12 AWG for up to 75 ft (23 m) or 10 AWG for up to 140 ft (46 m).

Y Special installation may be required where gasoline or volatile liquids are present − see NEC Article 511 or CEC Section 20.

802 589-A

OM-928 Page 12