Hobart Welding Products OM-487 manual Optional Auxiliary Power Receptacles, Gfci Receptacle Option

6-2. Optional Auxiliary Power Receptacles

3

4

2

Simultaneous Welding And Auxiliary Power

Output

Weld Current		120 V	240 V
	Watts	Receptacle	Receptacle
Amperes
		Amperes	Amperes
250	3500	31	15.5
225	4260	39	19
200	5140	46	23
150	6700	60	30
100	8000	62.4	31.2
50	8000	62.4	31.2
0	8000	62.4	31.2

YIf unit does not have GFCI re-

ceptacles, use GFCI- protected extension cord.

1. Auxiliary power decreases as weld current increases.

Combined output of all receptacles limited to 8 kVA/kW rating of the generator.

GFCI Receptacle Option

1120 V 15 A AC GFCI Recep- tacles GFCI2 and GFCI3

GFCI2 and GFCI3 supply 60 Hz single-phase power at weld/power speed. Maximum output from GFCI2 or GFCI3 is 2.4 kVA/kW. Cir- cuit breaker protection is the same as standard receptacles.

If a ground fault is detected, the GFCI Reset button pops out and the circuit opens to disconnect the faulty equipment. Check for damaged tools, cords, plugs, etc. connected to the receptacle. Press button to reset receptacle and resume operation.

.At least once a month, run engine at weld/power speed and press Test button to verify GFCI is working properly.

Australian Receptacle Option

2240 V 15 A AC Australian Re- ceptacles RC1, RC2, and RC3

Receptacles supply 60 Hz single- phase power at weld/power speed. Maximum output from each receptacle is 3.6 kVA/kW.

3Circuit Breakers CB1, CB2, CB3

CB1, CB2, and CB3 protect RC1, RC2, and RC3 from overload. If a circuit breaker opens, the recep- tacle does not work.

4 Circuit Breaker CB4

CB4 protects all the receptacles from overload. If CB4 opens, none of the receptacles work.

.Press button to reset circuit breaker. If breaker continues to

open, contact Factory Authorized Service Agent.

Ref. ST-187 602-A / Ref. ST-172 782

OM-487 Page 21