Repeat steps 1-6 for the DAY, EVE, and NITE periods. Afterwards, repeat steps 1-6 for 4 daily periods on Saturdays (Day 6), and 4 daily periods on Sundays (Day 7). The temperature display will show "6" for Saturdays, and "7" for Sunday times.

Note: If Programming Mode is not being used and Day/Night Mode is being used, only the Weekday - DAY and NITE settings can

be programmed.

DAY/NIGHT MODE

Your thermostat can be configured to change its temperature settings

from "DAY" to "NITE" when commanded from a remote location. If so, the thermostat will use the weekday "DAY" and the weekday "NITE" settings.

"REMOTE" and either "DAY" or "NITE" will be displayed when a command is sent from a remote location. You can use the arrow keys (-) to override the temperature settings, or press the Hold key to prevent any future remote changes.

Follow the procedure shown in Programming Mode, to change the programmed DAY and NITE settings.

PROGRAMMABLE ENERGY SAVER MODE

(PESM)

Your thermostat can be configured to allow a remote system to override it. The thermostat sends the temperature to the remote system. The remote system will use the temperature to determine whether or not to override the thermostat based on its own temperature settings.

"REMOTE" will be displayed when the remote system has control of the thermostat. You cannot use the arrow keys (-) or any other key on the thermostat to override the remote system. To resume normal operation of your thermostat, you must turn the energy saver feature off at the remote system.

13

Page 16
Image 16
Home Automation RC-100 owner manual DAY/NIGHT Mode, Programmable Energy Saver Mode, Pesm