HoMedics IB-SC405 First Time Setup, General Operation, Battery Information, Battery Replacement

Thank you for your HoMedics Digital Glass Scale purchase. This, like the entire HoMedics product line, is built with high-quality craftsmanship to provide years of dependable service. We hope you will find it to be the finest product of its kind.

First Time Setup

1.This scale operates on two lithium CR2032 batteries (pre-installed). There is a red strip under the lithium batteries to prevent battery drain in shipping. Remove the red strip before continuing with these instructions.

2.Some models have a static cling label on the lens to prevent scratching. Remove before use.

3.Set the “LB/KG/ST” unit of measure switch located on the back of the scale for pounds, kilograms or stones.

Note: The switch is pre-set to pounds.

4.The scale needs to be initialized before first use or after battery replacement. Press lightly on the scale platform. The display will turn on, then show “0.0” and automatically turn off. The scale is now ready for use.

Note: The scale may need to be initialized if it is moved or bumped.

General Operation

1.Place the scale on a flat, hard surface. Carpeted or uneven floors may affect accuracy.

2.Step on the scale positioning your feet evenly on the scale platform. Stand still while the scale measures your weight.

271. LBS

0

3.When your weight stabilizes, the display will flash, and then show your weight.

The weight reading will show for a few seconds. Then the display will return to “0.0” and turn off to conserve the battery.

It is normal for your weight to fluctuate during the day and from one day to another. Slight changes in your weight are normal. For best results:

1.Weigh yourself without clothing whenever possible. Clothes can vary in weight.

2.Weigh yourself at the same time of day under the same circumstances.

3.Allow for weight fluctuations due to food or drink in your system.

Battery Information

Your scale has two lithium batteries installed that will provide a long life of operation when used in a typical household.

Battery Replacement

1.Use 2 x CR2032 lithium batteries only.

2.Open the battery cover on the back of the scale by pushing the tab in the direction of the “open” arrow and lift up.

+ +

CR 2032 CR 2032

3.Insert a small screwdriver into the slot holding bracket and carefully pry up the battery until it pops out.

4.Place the new batteries with the “+” sign up on an angle with one side under the tabs and push down.

5.Close the battery cover. Be sure it clicks shut.

Low Battery

This scale is equipped with a low battery indicator. Replace the battery when “Lo” is displayed or readings grow dim or become irregular.

2 3