Figure 9
Figure 10

Assembly Instructions

Carefully remove all contents from the packaging and inspect the product to make sure all components have been received (Figure 1).

8.The fabric brush, lint brush, crease tool, and cloth covers may be stored inside the on-board storage compartment (Figure 8).

1.Insert the Telescoping Pole into the steamer. Align the pole grooves with the grooves inside the pole base and push down. Hand tighten the Pole Nut by turning clockwise (Figure 2).

2.Fully extend the Telescoping Pole. Open the 3 Clips on the pole and pull upwards (Figure 3). Close the clips and make sure the pole is securely locked into place.

3.Attach the Hanger Attachment. Align

the tabs in the Hanger Attachment with the grooves on the pole and push down (Figure 3).

4.Hang the Steam Nozzle Handle on the Hanger Attachment (Figure 4).

5.Place the Clothes Hanger with Clips on the Hanger Attachment and gently push down (Figure 5). Expand the Clothes Hanger by raising each side until it locks into place.

6.Clip the Lower Hanger on the Telescoping Pole (Figure 6).

7.Place the Water Filter inside the water reservoir by aligning the water filter outlet with the hole in the water reservoir and push down to secure (Figure 7).

NOTE:

The steamer will not operate without the water filter.

Figure 2

Hanger

Attachment

Clips

Figure 3

Figure 4

Figure 5

Figure 6

Figure 7

Figure 8

Instructions for Use

Before Beginning

Read all instructions including Important Safety Instructions and Warnings before use.

Filling the Water Tank

1.Turn the water tank upside down and unscrew the cap (Figure 9).

2.Hold the tank under clean cool tap water and fill

to the desired level. DO NOT fill past the MAX FILL line.

3. Once the tank is filled, screw the cap back on and turn over. Place the water tank in the

steamer water tank cavity. Make sure it is sitting securely (Figure 10).

NOTE:

Only fill the tank with clean cool water. DO NOT use HOT water.

• If the water in your area is extremely hard or has high mineral content, only use demineralized or distilled water.

Do not use any additives in the water such as fabric softeners, scents, bleach, and starch. They will damage the garment steamer and your garment.

6

7

Page 4
Image 4
HoMedics PS-350 instruction manual Assembly Instructions, Instructions for Use, Before Beginning, Filling the Water Tank