Stanley Black & Decker DS06 Nose Sprocket Disassembly And Assembly, Maintenan & Adjustments

MAINTENAN & ADJUSTMENTS

5. Apply a few drops of oil to the rivet hub (Figure 22).

Figure 22. Applying the Oil

6.Turn the spinner crank while slowly running the take- up handle inward (approximately one full revolution) until the rivet head is formed (Figure 23).

NOTE:

The take-up handle provides pressure while the spinner anvil forms the rivet head.

Figure 23. Forming a Rivet Head

Figure 24. Spinner Oiling Chambers

NOTE:

The rivet spinner is equipped with oiling chambers and should be maintained periodically with a light- weight oil (Figure 24).

NOSE SPROCKET DISASSEMBLY AND ASSEMBLY

1.Using the bench mounted chain breaker (see acces- sories), line up the 1/4 inch hole in the side of the chain breaker anvil with the chain breaker punch. Punch out the six nose sprocket rivets. See Figure 25.

Figure 25. Punching Out Nose Sprocket Rivets

2.Insert a straight blade screw driver to spread the bar nose rails just enough to remove the old nose sprocket. Use a rag or paper towel to clean the nose sprocket area. See Figure 26.

Figure 26. Removing Old Nose Sprocket

DS06 User Manual ◄ 17