![REPLACING THE CHAIN BREAKER PUNCH](/images/new-backgrounds/87183/8718331x1.webp)
MAINTENAN & ADJUSTMENTS
REPLACING THE CHAIN BREAKER PUNCH
If the chain breaker punch (P/N 22801) becomes worn or damaged, use the following procedures for replace- ment.
1.Remove the punch by loosening the set screw (Figure 16).
Figure 16. Removing the Punch
2.Insert a new punch into the holder and push it up until it is fully seated (Figure 17). Secure the punch to the chain breaker holder by fully tightening the set screw.
Figure 17. Replacing the Punch
SPINNING RIVETS
The following procedures explain how to spin rivets us- ing Stanley’s
1.Mount the rivet spinner flush with the side or front of a flat, clean work surface (Figure 18).
16 ► DS06 User Manual
Figure 18. Rivet Spinner Mounting
2.Lay the chain across the plastic chain supports and then rotate the supports so the rivet head is cen- tered between the
Figure 19. Positioning the Chain
3.Turn the
Rivet Spinner | ||
Handle | ||
Crank | ||
|
Figure 20. Securing the Chain
4.Turn the rivet spinner crank a few times to center the rivet hub in the spinner anvil (Figure 21).
Rivet SpinnerHandle Crank
Figure 21. Centering the Rivet Hub