ASSEMBLY

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

Front handle

See Figure 2.

NOTE: For shipping purposes only, the handle is located underneath the drive shaft housing. The handle must be rotated before operating the trimmer.

Slightly loosen the wing nut on the handle.

Rotate the handle on the drive shaft housing at the loca- tion indicated by the label on the shaft.

Retighten the wing nut to secure the handle in place.

curved shaft GRASS DEFLECTOR – mightylite 26cs

See Figure 3.

WARNING:

The line cutting blade on the grass deflector is sharp. Avoid contact with the blade. Failure to avoid contact can result in serious personal injury.

Remove the bolt, washer, and wing nut from grass deflector.

Press the grass deflector onto the bottom of the curved shaft as shown.

Insert the bolt through the grass deflector and the bracket on the curved shaft.

Place the washer on the bolt.

Place the wing nut on the bolt and tighten securely.

straight shaft GRASS DEFLECTOR – mightylite 26ss

See Figure 4.

Remove the wing nut and mounting bracket from the grass deflector.

Assemble straight shaft grass deflector to drive shaft so that the pin in the grass deflector fits in the locator hole in the lower side of the drive shaft near the gear head.

Place the mounting bracket over the drive shaft so the square tab on the mounting bracket fits into the slot in the straight shaft grass deflector.

Rotate the mounting bracket so the screw on the grass deflector goes into the slot on the mounting bracket.

Reinstall the wing nut and tighten securely.

OPERATION

WARNING:

Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury.

Before each use, inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product until all missing or damaged parts are replaced. Please call 1-800-242-4672 or contact an authorized service center for assistance.

WARNING:

Always wear eye protection with side shields marked to comply with ANSI Z87.1. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.

WARNING:

Never use blades, flailing devices, wire, or rope on this prod- uct. Do not use any attachments or accessories not rec- ommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury.

FUELING AND REFUELING the trimmer

FUEL MIXTURE

This product is powered by a 2-cycle engine and requires pre-mixing gasoline and 2-cycle lubricant. Pre-mix unleaded gasoline and 2-cycle engine lubricant in a clean 1 gallon container approved for gasoline.

Recommended fuel: This engine is certified to operate on unleaded gasoline intended for automotive use.

Mix Homelite Premium Exact Mix lubricant with gasoline according to the instructions on the package. If Premium Exact Mix lubricant is not available, use a high quality syn- thetic 2-cycle engine lubricant, mixed at 2.6 oz. per gallon (US).

Page 6 — English

Page 10
Image 10
Homelite 26SS manuel dutilisation Operation, Fuel Mixture