ASSEMBLY
ASSEMBLING THE BLOWER TUBES
See Figure 2.
nScrew the nozzle onto the upper blower tube and tighten securely. Check tightness after initial run and retighten if needed.
nPlace clamp around the neck of the blower housing outlet. Do not tighten the wing nut yet.
nAlign the locking tab on upper blower tube with the slot in the blower housing outlet. Push the tube into the housing. Twist to lock into place.
nRotate the tube so the nozzle is pointing upward as shown. Tighten the wing nut securely.
nTo remove the tubes, loosen the wing nut on the clamp. Rotate the tubes to unlock them and then remove them from the blower housing outlet.
INSTALLING THE VACUUM BAG
See Figures 3 - 4.
Fig. 4
INLET COVER
DOOR
nRemove the nozzle and upper blower tube from the blower.
nUnzip the vacuum bag and place the adaptor inside as shown.
nAlign the locking tab on the bag adapter with the slot in
the blower housing outlet. Push the bag adaptor into the | KNOB |
housing. Twist to lock into place. |
|
nTighten the wing nut securely.
nRotate the vacuum bag until the shoulder strap is upright.
nMake sure the vacuum bag is zipped and closed before starting the unit.
INSTALLING THE VACUUM TUBES
See Figures 5 - 6.
To install the vacuum tubes:
nScrew the upper and lower vacuum tubes together and tighten securely.
�n Loosen the knob on the inlet cover door and open. Place the notch in the support arm of the upper vacuum tube under the hinge of the inlet cover door.
�n Push the upper vacuum tube into the blower housing.
�n Align the upper vacuum tube knob with the hole in the housing and tighten securely.
To remove the vacuum tubes:
�n Loosen the upper vacuum tube knob.
�n Remove the vacuum tubes from the blower housing.
�n Close the inlet cover door and tighten the knob securely.
Fig. 5
HINGE
NOTCH IN
SUPPORT ARM
UPPER
VACUUM TUBE
KNOB
Fig. 6
Page 8
