ASSEMBLY

WARNING:

Stop the engine and disconnect the spark plug wire before installing parts, making adjustments, cleaning, or when not in use. Failure to do so could result in possible serious personal injury.

ASSEMBLING THE BLOWER TUBES

See Figure 3.

Screw the nozzle onto the blower tube and tighten securely. Check tightness after initial run and retighten if needed.

Place clamp around the neck of the blower housing outlet. Do not tighten the knob yet.

Align the locking tab on blower tube with the slot in the blower housing outlet; push the tube into the housing. Twist to lock into place.

Rotate the tube so the nozzle is pointing upward as shown. Tighten the knob securely.

To remove the tubes, loosen the knob on the clamp. Rotate the tubes to unlock them; remove tube from the blower housing outlet.

INSTALLING THE VACUUM BAG

See Figures 4 - 5.

Remove the nozzle and blower tube from the blower.

Unzip the vacuum bag and place the adaptor inside as shown.

Align the locking tab on the bag adaptor with the slot in the blower housing outlet; push the bag adaptor into the housing. Twist to lock into place.

Tighten the wing nut securely.

Rotate the vacuum bag until the shoulder strap is upright.

Make sure the vacuum bag is zipped and closed before starting the unit.

NOZZLE

UPPER

KNOB

 

BLOWER TUBE

 

Fig. 3

BAG ADAPTOR

VACUUM BAG

Fig. 4

Fig. 5

Page 10

Page 10
Image 10
Homelite UT08947 manual Assembling the Blower Tubes, Installing the Vacuum BAG, See Figures 4